Hardware requirements

Delsys hardware

  • Delsys Trigno base station.

    Trigno Lite is also supported but not recommended for use with QTM. The Trigno Lite does not support hardware synchronization and the bandwidth is limited to 4 data slots.

  • Delsys Trigno sensors, see list of supported sensors below.

Hardware needed for synchronization

  • Qualisys Camera Sync Unit, or a sync/splitter cable if you are using an Oqus system.
  • Delsys Trigger Module

The following types of sensors are supported in the Delsys Trigno API integration.

EMG sensors

  • Trigno Avanti Sensor
  • Trigno Mini Sensor
  • Trigno Duo Sensor
  • Trigno Quattro Sensor
  • Trigno Spring Contact Adapter
  • Trigno Snap Lead Sensor

AUX sensors

  • Trigno Analog Input Adapter
  • Trigno Goniometer Adapter
  • Trigno Load Cell Adapter
  • Trigno EKG Biofeedback Sensor
  • Trigno 4-Ch FSR Adapter

Sensors with limited support

  • Trigno Galileo Sensor
  • Trigno Maize Sensor

Trigno classic and IM sensors are not supported by the Delsys API integration. If you have Trigno legacy sensors, you can use the Delsys Trigno SDK integration, see Delsys Trigno EMG (SDK legacy integration).

Version information

The following firmware is required for use with the Delsys API integration:

  • Delsys Trigno base station firmware: MA2919-BE1506-DS0806-US2008-DA0901/0000.
  • Sensor firmware: 40.49.

For more information about compatibility of Delsys firmware and software versions or up/downgrading Delsys firmware, refer to Delsys documentation or support.

USB drivers

The API integration requires that the 64-bit version of the Delsys USB drivers is installed. The easiest way to install the correct drivers is by installing the Delsys Trigno Discover software. For more information, refer to Delsys documentation or support.